Butterfly Card

Butterfly Card

Butterfly Card Idea

This Butterfly Card uses the Spellbinders Brilliant Butterfly die-set, and the lace flower frame from the Tallulah Frill die-set by Spellbinders.

Spellbinders Card Tutorial

As you can see there’s a lot going on in this beautiful butterfly card.  I needed a change of pace and just couldn’t help myself!; I knew I wanted to create something where everything just popped out at once.  It had to be fun, youthful, and full of life!

how to make a dimensional card

The Supply List

To make this card, just as I show it,  you’re going to use the following:

Pink Cardstock

Prima Amelia Rose paper pad

Designer Art Glitter glue

Scor-tape

Sentiment Stamp

Pink and white flowers from your stash

Black card stock

Flat-back pearls (by the strand in this case)

Spellbinders Tallulah Frill die-set

Spellbinders Brilliant Butterfly die-set

Die-cutting Machine (Spellbinders Platinum 6)

Spellbinders Tool n’ One

Scoring Board

Paper Trimmer

3D foam dots or fun foam

Spellbinders NEW Monthly Die Cutting Clubs

The Tutorial

#1 – Trim your pink card stock to 8×6. Place it horizontally on your scoring board and score right down the middle, at 4 inches. Fold your card and use your bone folder to flatten the crease.  This is your card base.

#2 – Trim your designer paper to 5 7/8 by 3 7/8. Use your art glitter glue to adhere it to the top of your base. Center this as best as you can.

#3 – Because I knew that my card would wind up being top heavy or front heavy, and I want it to be able to stand upright, I trimmed another piece of paper from the same collection, using the measurements mentioned above, and glued it down to the inside of my card.  I also added my stamp on another piece of paper and glued it on the back of the card for added support.

how to make a dimensional card

I thought this lined paper from the Amelia Rose collection would be PERFECT for the inside! What do you think?

stamped image

#4 – So now that we have the first outer layer and the inside taken care of, we move on to die-cutting our pieces.  You’ll die-cut the lace flower frame from the Tallulah Frill die-set in black card stock; and the butterfly and two sets of leaves from the Brilliant Butterfly die-set.  You’ll cut these in the Amelia Rose papers.

#5 – If you look closely, you’ll find that I also cut and layered a strip of the lined paper to kind of separate the lighter part from the darker part of the designer paper (first layer).  This is not necessary, but if you pay close attention to details like I do, you may want to add this element to your card.

Fun birthday card tutorial

Trim a piece of pink card stock to 2 7/8 by 4 7/8 and glue down your lace flower frame on it.  Then you’ll glue this down (off-centered) to the top of your card.

… and the decorating

#6 – Trim a piece of designer paper to 3 7/8 by 2 5/8.  Add your foam dots to the back of this; then apply it on top of your card (off-centered once again).  Apply your flat-back pearls around it, creating a frame.  You may use your art glitter glue to apply them.

#7 – Stamp a sentiment on pink card stock, square it out, and with your foam dots, apply it on top of the frame that you just created.

#8 – Lastly, you’ll embellish with flowers and the butterfly and leaves die-cuts.

In closing, creating cards such as these are not complicated.  Just take it one step at a time; and if you make an error, it’s ok. That is how we learn.

Thank you for stopping by. Until next time!